No drilling, tapping or major alteration. Guaranteed to hold zero. Can be removed and reinstalled easily. Requires a long eye relief scope. Made in the USA of top grade military allan aircraft aluminum. Will also fit the 24-47 and 52C. Rings not included - accepts Weaver rings.

Installation instructions for the 48 YUGO MAUSER SCOUT MOUNT

Remove the rear sight by pushing the pin out and remove the spring. Slide the special nut into the grove at the rear of the sight. Place the mount into the rear sight with the bottom hole over the special nut and the (2) side holes to the front of the gun. 

Put the 10-32 x 5/8 flathead screw through the mount and into the special nut. (Do not tighten at this time)  

Line the 6-32 tapped holes (in side of the mount) up with the holes in the side of the receiver. It is very important that these holes line up to keep from damaging the threads when the screws are installed. Insert the (2) 6-32 x 5/16 socket head cap screws through the hole the pin was in and into the mount. Lightly tighten the (2) 6-32 screws. 

Tighten down the 10-32 x 5/8 flathead screw and then the (2) 6-32 x 5/16 socket head cap screws. You don’t need to get the (2) 6-32 screws very tight! 

Insert the 10–32 x ½ set screws into the threaded holes at the top of the mount & run these screws in until it puts pressure against the receiver and then tighten. Re-tighten the 10-32 x ½ set screws. After tightening the 10-32 set screws – Do not try to tighten or loosen the 6-32 side screws as the top set screws hold pressure on the 6-32 screws.