Steyr M95 Carbine Scout Mount Weaver Short Ladder - S&K Scope Mo
Item #: SK8070
S&K Mounts 8070
UPC: none
Weight: 2.00 pounds
Product Description
Steyr M95 Carbine Scout Mount Weaver Short Ladder - S&K Scope Mount
Will also fit the Budapest & Austrian M34 Stutzen
No drilling, tapping or major alteration. Guaranteed to hold zero. Can be removed and reinstalled easily. Made in the USA of top grade military allan aircraft aluminum. Use Weaver type rings (not included). Requires a long eye relief scope.
Installation instructions for the Styer M95 Carbine
To install this mount, it is necessary to remove the rear sight from your Styer. You will need to first remove the top wood piece in front of the rear sight. To remove the sight push out the pivot pin & remove the screw holding the spring in place.
After removal of the rear sight file off any burrs on the .096 diameter pivot pin you removed as this part will be reused. Insert the special tapered nut supplied with your S&K mount into the slot that the spring came out of. Place the bottom part of the S&K mount into the .314 wide slot at the rear of the receiver with the front hole on the underside over top of the special tapered nut.
Will also fit the Budapest & Austrian M34 Stutzen
No drilling, tapping or major alteration. Guaranteed to hold zero. Can be removed and reinstalled easily. Made in the USA of top grade military allan aircraft aluminum. Use Weaver type rings (not included). Requires a long eye relief scope.
Installation instructions for the Styer M95 Carbine
To install this mount, it is necessary to remove the rear sight from your Styer. You will need to first remove the top wood piece in front of the rear sight. To remove the sight push out the pivot pin & remove the screw holding the spring in place.
After removal of the rear sight file off any burrs on the .096 diameter pivot pin you removed as this part will be reused. Insert the special tapered nut supplied with your S&K mount into the slot that the spring came out of. Place the bottom part of the S&K mount into the .314 wide slot at the rear of the receiver with the front hole on the underside over top of the special tapered nut.
Slide the .096 diameter pivot pin into the hole on the receiver & then into the hole in the mount. Tap the pin in with a punch until it is flush with the side of the receiver. Put the 10-32 x ½ flathead screw down through the top of the mount & into the special tapered nut & tighten. Insert the10-32 x ½ socket set screw through the top of the mount & tighten.
