6 Shot Sidesaddle for Winchester 1200/1300 Defender and Blackshadow 12 Gauge Shotguns – TacStar

Shell Holder Material: Polymer
Backing Plate: Aluminum
Capacity: 6 12 Gauge Shells
Fits: Winchester 1200/1300 Defender and Blackshadow 12 Gauge

Features:
Unbreakable, corrosion resistant polymer shell holder
Rugged, aluminum backing plate
Easy mounting, no gunsmithing
Mounting screws included

Hardware Included: 2 allen wrenches, 1 Long screw and washer to replace receiver pin, 1 1/4-28 screw, 6 shot shotshell holder with 6 allen screws, and aluminum backing plate.

The TacStar Sidesaddle mounts 6 extra rounds on your shotgun in a convenient and accessible location for fast reloading. The tough, weatherproof shell carrier is attached to an aluminum mounting plate that installs directly on the shotgun receiver.

Installation is easy, and in most cases requires no alterations to the shotgun. All mounting screws are included, no gunsmithing required.

FOREND ADVISORY: If your shotgun is equipped with a field grade forend that extends onto the sides of the receiver, it will hit the 6 shell SideSaddle and not cycle fully. To remedy; shorten the length of forend or equip the shotgun with a TacStar or Pachmayr forend.

TacStar 6 Shot Sidesaddle Winchester 1200/1300 FN TPS Installation Instructions

1. Using the supplied ¼-28 screw with washer, push out the trigger group pin located above the trigger. Push the pin out from the ejection port side of the receiver so the threads of the screw are exposed on the other side.

2. Place the bracket on the bottom of the SideSaddle mounting plate, inside the loading port, and slide upward.

3. Align the mounting plate so the threaded hole matches up with the screw that you placed in the receiver. Start the screw into the plate and carefully tighten. Do not overtighten. Overtightening may lock up the shotgun’s action. To remedy, simply loosen the screw.

4. Snugly tighten the remaining small screws for the shot shell holder into the mounting plate.