Functions in both open or closed positions. The ultimate compact, tough design. Includes rear pistol grip. Quick release button allows buttstock to fold/unfold instantly and locks arm securely into open or closed position.  Sling swivel stud included. Reversible for right or left-handed shooters. 

Installs without gunsmithing in a few simple steps.  Folds to only 29" (with 18.5" barrel length) for compact storage and easy carry.  Made in the USA of DuPont Extreme Reinforced Polymer. Includes adapters and mounting hardware for all supported models.

Fits:

Maverick 88 12ga & 20ga(proud fit), Mossberg 500/535/590/835 12ga & 20ga(proud fit), Remington 870 12ga, and Winchester 1200/1300 12ga & 20ga(proud fit) Shotguns. 

Stock is pre-drilled to accept shell holder (not included). Lifetime Warranty. Will also fit Norinco. 

 

ATSK0500 Shotgun Soft Rubber Butt Pad will not fit on Top Folding Stock (ATT0600)

Does not include a buttstock pad recoil extender. ATI does not make one for this. Per Jen, stock would not fold correctly if one on the stock. She is not aware of any 3rd party product that will work.

Shotforce Top-Folding Shotgun Stock Instructions

1: Remove Original Stock

Begin by removing the existing recoil pad from your stock using a phillips head screwdriver. Next using a long flat head screwdriver or appropriate socket, remove the stock bolt. You can now remove the old stock from the receiver.

2: Rear Rest to Main Support

Begin with the main support, skinny side to the right. Take the rear rest and attach to the main support’s skinny side. Next, turn the stock over (skinny side now to the left) and install the small TFS pin into the rear rest until flush.

After installing the small TFS pin, turn the stock over (rear rest to the right) and set the small TFS washer onto the rear rest. Using a phillips head screw attach the small TFS washer.
Note: when tightening the screw, you will need to use an allen wrench in the small TFS pin to the pin from moving.

3: Grip Assembly Installation to Main Support

Take the grip assembly and attach to the main support making sure the folding button is seated into the proper slot. (Note: Before installing the large TFS pin, determine which side you would like to have the sling stud attached to as it will attach to the opposite of the installed pin). Next, turn the stock over and install the large TFS pin into the grip assembly until flush.

After installing the large TFS pin, turn the stock over and set the large TFS washer onto the grip assembly. Install the sling stud to the large TFS washer.
Note: when tightening the sling stud, you will need to use an allen wrench in the large TFS pin to hold the pin from moving and an open face or spanner wrench to tighten the sling stud.

4: Adapter Installation

Place the appropriate adapter into the pistol grip. (Mossberg and Maverick do not need adapters, so the grip will seat directly to the receiver). Press the adapter into place.

5: Grip Assembly Installation to Receiver

With the main support in the open position place pistol grip flush against the receiver.

With the main support folded and using the appropriate bolt and washers, tighten the pistol grip to the receiver with the appropriate allen wrench.