**MAC 10 Recoil Buffer - Buffer Tech

Unfortunately, this item has been discontinued by Buffer Technologies. We do try to offer similar items when an item is discontinued by the manaufacturer.
Take an additional 5% off any other item at Galati International by using PROMO CODE: DISCONTINUED during checkout.
**MAC 10 Recoil Buffer - Buffer Tech

Processing...
Item #: BTR101
THIS ITEM IS DISCONTINUED
Unfortunately, this item is no longer available for purchase. Use Promo Code: DISCONTINUED for 5% off any other item purchased at Galati International.
Manufacturer: Buffer Technologies M10
UPC: 855727000716
Weight: 0.50 pounds

Product Description

The Buffer Technologies Recoil Buffer for the MAC 10 replaces the original factory unit. It differs from the original one in two very beneficial ways. First, it is made of a resilient, high-impact polyurethane. This material is capable of enduring the normal firing conditions that the factory unit couldn't stand up to. Second, it allows the recoil spring to rest against the rear support plate. This elimintes the severe compression between the bolt and the rear support plate so that the recoil spring, which had a tendency to chew up the buffer, no longer proves self destructive to the weapon. The Recoil Buffers will work with any caliber. Those who install Recoil Buffers into their Mac will find that the recoil is reduced and muzzle stability is increased which is very important for rapid fire. The recoil buffer is simple to install and requires no modification to the firearm.

Installation of MAC 10 recoil buffer
1. Make sure firearm is unloaded.
2. Remove bolt and recoil spring assembly from receiver.  Pull ejector pin out the back of the buffer and support plate.
3. Remove and discard old buffer completely.  Install new buffer in place of original.
4. Push ejector pin back plate and new buffer.  Recoil spring will rest against support plate.
5. Reassemble firearm.