M91 Finish Russian Dragoon P Series M24 M27 M28 Scout Mount Weaver Style - S&K Scope Mounts
Item #: SK9190
S&K Mounts 9190
UPC: none
Weight: 2.00 pounds
Product Description
No drilling, tapping or major alteration. Guaranteed to hold zero. Can be removed and reinstalled easily. Made in the USA of top grade military allan
aircraft aluminum. Use Weaver type rings (not included). Requires a long eye relief scope.
Installation instructions for the Finish M91, Russian M91, Dragoon
To install this mount, it is necessary to remove the rear sight from your rifle. To remove the rear sight push out the pivot pin, remove the ladder sight & the spring.
After removal of the rear sight place the S&K Mount between the (2) ears sticking up where the ladder sight pivot pin was. Keep the lettering (1891) on the underside of the mount toward the front of the rifle. Line the 4-40 tapped holes in the side of the mount up with the pivot pin holes & insert the (2) 4-40 x 3/8 socket head cap screws. The holes in the rifle sight must line up with the threads in the mount or you can cross-thread the tapped holes in the S&K Mount. Tighten the screws until you feel a slight resistance. They do not need to be very tight.
Installation instructions for the Finish M91, Russian M91, Dragoon
To install this mount, it is necessary to remove the rear sight from your rifle. To remove the rear sight push out the pivot pin, remove the ladder sight & the spring.
After removal of the rear sight place the S&K Mount between the (2) ears sticking up where the ladder sight pivot pin was. Keep the lettering (1891) on the underside of the mount toward the front of the rifle. Line the 4-40 tapped holes in the side of the mount up with the pivot pin holes & insert the (2) 4-40 x 3/8 socket head cap screws. The holes in the rifle sight must line up with the threads in the mount or you can cross-thread the tapped holes in the S&K Mount. Tighten the screws until you feel a slight resistance. They do not need to be very tight.
Insert the 10-32 x ½ brass socket set screw into the front top tapped hole of the S&K Mount & tighten this screw. Tightening this screw will put down pressure on the rear of the mount causing the 4-40 screws to become tight. DO NOT try to tighten the 4-40 screws with the front brass screw tight.
Insert the 10-32 x ¼ pointed socket set screw into the top rear threaded hole of the S&K Mount. This screw needs to be tightened only enough to keep the rear of the mount from shifting sideways. Over-tightening this screw will lift the rear of the S&K Mount off the pad the rear rests on.
