No drilling, tapping or major alteration. Guaranteed to hold zero. Can be removed and reinstalled easily. Includes 1" fully machined, horizontally split scope rings and is windage adjustable. Requires a long eye relief scope. Made in the USA of top grade military allan aircraft aluminum.

Installation instructions for the CZ24 Scout Mount

Remove the rear sight by pushing the hinge pin out and then remove the sight and spring.
Center the mount over the rear sight area and the same time slide the bottom of the mount into the undercut at the rear while pushing down on the front. You may need to tap the mount lightly back into the receiver where the pin was removed. Install the two 6-32 x 5/16 screws into the pin holes of the mount. Place the two 10 – 32 x ½ set screws into the holes provided and tighten.