**AR 180 Scope Mount - Includes Rings - S&K Scope Mounts
Unfortunately, this item has been discontinued by S&K Mounts. We do try to offer similar items when an item is discontinued by the manaufacturer.
Take an additional 5% off any other item at Galati International by using PROMO CODE: DISCONTINUED during checkout.
Take an additional 5% off any other item at Galati International by using PROMO CODE: DISCONTINUED during checkout.
Item #: SK1665
THIS ITEM IS DISCONTINUED
Unfortunately, this item is no longer available for purchase. Use Promo Code: DISCONTINUED for 5% off any other item purchased at Galati International.
Unfortunately, this item is no longer available for purchase. Use Promo Code: DISCONTINUED for 5% off any other item purchased at Galati International.
UPC: none
Weight: 2.00 pounds
Product Description
No drilling, tapping or major alteration. Guaranteed to hold zero. Can be removed and reinstalled easily. Includes 1" fully machined, horizontally split scope rings and is windage adjustable. Requires 5/8" risers (not included). Made in the USA of top grade military allan
aircraft aluminum.
Installation instructions for the AR 180
1. Place the scope mount base with the wide end of the dovetail toward the front (toward the muzzle ) over the dovetail on the receiver.
2. Slide the mount base forward until it stops. Tap it forward with a hardwood block or rubber mallet.
3. Lock it by tightening the set screw.
ADDITIONAL INSTRUCTIONS FOR THE #1665
1. Put one 5/8th riser block into each hole in the top of the base, making sure the holes in the riser blocks line up with the axes of the bore.
2. Tighten the four cone point set screws.
3. Install the scope mounting rings according to the instructions found on the box, remembering that there is windage adjustment in each of the 5/8th riser blocks.
Installation instructions for the AR 180
1. Place the scope mount base with the wide end of the dovetail toward the front (toward the muzzle ) over the dovetail on the receiver.
2. Slide the mount base forward until it stops. Tap it forward with a hardwood block or rubber mallet.
3. Lock it by tightening the set screw.
ADDITIONAL INSTRUCTIONS FOR THE #1665
1. Put one 5/8th riser block into each hole in the top of the base, making sure the holes in the riser blocks line up with the axes of the bore.
2. Tighten the four cone point set screws.
3. Install the scope mounting rings according to the instructions found on the box, remembering that there is windage adjustment in each of the 5/8th riser blocks.