Shotforce Mossberg Winchester Remington Maverick Shotgun Rear Pistol AR-15 Style  - ATI Outdoors

The Shotforce Rear Pistol Grip from ATI is made from DuPont Extreme Temperature Glass Reinforced Polymer. It has an AR-style pistol grip with a slim ergonomic design for comfort. The textured grip design increases control and accuracy.

The RPG has a top-mounted sling loop for easy sling attachment, it is easy to install, and all supported model adapters and mounting hardware is included.

Features:

DuPont Extreme Temperature Glass Reinforced Polymer

AR-Style Grip

Slim ergonomic design

Textured Grip

Top-Mount Sling Loop

Easy Installation

Made in the USA

Fits: Maverick 88 12ga & 20ga, Mossberg 500/535/590/835 12ga & 20 ga, Remington 870 12ga, and Winchester 1200/1300 12ga & 20ga.

ATSRG0200: Shotgun Rear Pistol Grip Assembly
Step #1 Remove the existing recoil pad from your stock by unscrewing the two phillips head screws in the rear of the pad

 Step #2 Use a long flat head screwdriver or the appropriate socket with extension to remove the stock bolt from the inside of the opening in the rear of the stock.

 Step #3 Select the correct adapter for your shotgun. The Mossberg and Maverick require no adapters. The Remington/Norinco and Winchester adapters are marked.

 Step #4 Select the mounting bolt supplied for your shotgun. Note: Norinco 98 Series is for Law Enforcement only, a metric 6x50mm bolt must be purchased for the Norinco shotgun.

 Step #5 Place the bolt, with supplied washer through the back of the grip and adapter (if used).

 Step #6 Secure to the shotgun receiver by tightening the bolt using an allen wrench.

 Step #7 Place the pistol grip end cover at the rear of the grip and press into place.